General Information
How to Access OneSense Configuration Options
OneSense devices are equipped with a USB port. Using a data transfer USB cable you can access the configuration opetion. This is very useful during the POC (proof-of-concept) phase of a project as it allows you to easily change certain settings - ...
How to Turn a Device ON
Turning a Device ON Acoustic signals accompany LED color change in some OneSense models. See LED indication description for more information on differnet device states. To Switch a device ON/OFF - hold magnet on top of the ON/OFF symbol until LED ...
How to Connect a Sensor to a Terminal Block
Connecting a Sensor to a Terminal Block OneSense is equipped with pluggable terminal connectors to ease the process of wiring sensors to the device. Unplug the terminal blocks from the header before beginning sensor wiring. This will help see the pin ...
How to Open Enclosure Lid
How to Open Enclosure Lid There are 4 quick assembly screws located on each corner of the lid. Use Philips-head screwdriver to open/close the lid.
Modes of Operation
Modes of Operation Inactive Mode OneSense is switched off. No measurements are conducted. All electronic modules except the real-time clock are in lowest power consumption state to preserve battery. The inactive mode should be engaged during ...
Hardware Overview
Hardware Overview
General Information and Safety
OneSense Telemetry Devices General Information and Safety Before using the device, please, read this user guide thoroughly. Text Highlights Definitions Warning Note Hint Alert Idea Safety Ensure installation of the Device meets applicable state and ...
How to Load Firmware
Unzip archived firmware files. Remove device's lid and install batteries in battery holder (observe polarity). Connect battery holder to your device. If battery holder is already connected to your device, disconnect it before installing batteries. ...